As I mentioned earlier, I’m in the process of developing a 3-octave psaltery. After crunching the numbers in a spreadsheet, and drawing up the plans in CAD, I was just about ready to go…

Except I’d never gone this low before: that is, I’d never strung a psaltery to be played as low as the instrument that I was proposing. (I’m planning to have the 3-octave model start on G2, a full octave lower than my current model.)

So, I made a test-model. It wasn’t rocket science. I just took a big slab of some Ash (or was it Elm?) that had been collected from my yard, and popped a couple of tuning pins in each side. After adding a basic bridge and a wound string, I was ready to start testing the string lengths, tension, and tone.

The main reason for this sidetrack is that I would imagine it would be a real drag to build, drill, and string an entire 35″ long psaltery, only to have the lowest strings sound bad because I didn’t double check to see if all the stringing “rules” that I’d discovered through trial and error on my smaller psalteries were still valid on a larger scale.

So far, so good.