« Crop Circle Rosette Microplane Sanding Discs »
Eric
Posted on: Tuesday, December 18, 2007 at 5:15 pm
Tools and Equipment, Building.
You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.
A Burled Walnut Ring
December
18th
Eric
I used a nifty new tool today to cut a burled walnut rosette ring. It is very similar to a standard circle cutter for a drill press, but instead of one cutter, it has two - one on each side.
By using two cutters, I can cut out both the inner and outer diameters of the ring simultaneously, and the arms are much more balanced.
Here’s a shot of the tool, along with the ring it cut in a matter of seconds. It was cut from a reinforced double-ply of burled walnut veneer.
Posted on: Tuesday, December 18, 2007 at 5:15 pm Tools and Equipment, Building. You can follow any responses to this entry through the RSS 2.0 feed.
You can leave a response, or trackback from your own site.
very nice!
December 19th, 2007 at 11:26 am